Color pooling
Multicolor yarn is so fun to work with and relatively easy to achieve. One of the ways to achieve cheerful, multicolor yarn is to pool color in a shallow dye bath. Adding one color at a time gives you control over the color placement. Keeping the water shallow keeps the pigment in sections making the color pool around one area of yarn.
Once the yarn in the dye vessel is hot but not simmering, add the dye water from the cup to one edge of the yarn. An easy way to think about this is to mentally divide your yarn up like a pie into quarters. Fill one-quarter of your yarn pie with the dye. Allow this dye to absorb fully into the yarn before moving on. The water in the area should be completely clear.
Remove one-half cup of water from the dye bath.
Supplies:
- 4 colors of acid dye
- Citric acid
- A skein of undyed yarn Egret
- Slow cooker or stockpot
- Tongs
- Several small cups
Getting started:
Presoak your yarn. While your yarn is soaking, fill your dye bath vessel with just a few inches of water and a splash of acid. For one skein of yarn, I use one tablespoon of citric acid. Dissolve the acid into the water. Once the yarn is presoaked, add the yarn to the dye vessel. The water line should be at the same level as the yarn. Add heat. If you are using a slow cooker, turn it on high. If you are working with a stockpot on a stove or a hot plate, a medium/medium-high setting will work. The yarn should be hot throughout this process but not simmering. Whatever dye vessel you are using, you want the yarn to fill the vessel in one even layer without any extra room around the yarn. Extra room around the skein will give the dye room to move freely, which will disperse the color too much for this effect.
Adding the first dye color:
In a small cup, add one-half cup of water and a quarter teaspoon of your first dye color. Make sure you wear a dust mask and gloves for this part. Dissolve the dye in the water.
Once the yarn in the dye vessel is hot but not simmering, add the dye water from the cup to one edge of the yarn. An easy way to think about this is to mentally divide your yarn up like a pie into quarters. Fill one-quarter of your yarn pie with the dye. Allow this dye to absorb fully into the yarn before moving on. The water in the area should be completely clear.
Remove one-half cup of water from the dye bath.
Adding the second dye color:
In a small cup, add one-half cup of water and a quarter teaspoon of your second dye color. Dissolve the dye fully in the water. Add the prepared dye and water to another quarter of the yarn. The direct opposite side of the first quarter tends to work well. Allow the dye to absorb fully before moving on. The water should be completely clear. Remove a half cup of water from the dye bath.
Adding the last two colors:
Repeat the same process as the first two colors for the last two colors. Make sure you remove a half cup of water each time. The color pooling happens best in shallow water so removing a half cup of water each time keeps the water level low.
